naiveplayer88

Forum Replies Created

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • naiveplayer88
    Participant

    Now understood a little bit more how resolutions works…
    Obviously leaving DEFAULT

    (RENDERING 0,5 minimum) LARGE 2134X1317 NORMAL 1601X1317 SMALL 1319X1317
    (RENDERING 1) LARGE 4267X2633 NORMAL 3202X2633 SMALL 2638X2633
    (RENDERING 2) LARGE 8535X5267 NORMAL 6405X5267 SMALL 5276X5267

    (Before I was using R2 Large… )

    —————————————————————————

    I think I have the last of VorpX, anyway i’ll check update or reinstall it…

    Have I always to disconnect antivirus?? I don’t use OBS when playing, or MSI afterburner… now for vr I have fpsVR software

    Reset factory? I will try in case the new tries fails…

    My latest update of GPU are from FF15, but watching Pitool suggestion i’m in for that.

    I try new resolutions and I let you know, I hope the “distortion” fades away
    Thanks

    naiveplayer88
    Participant

    in the pimax site the last update is in february, not yesterday.

    I think it is for the lack of controllers and basestations or the fact that my GPU is not at her last update, but is it not too old driver nvidia

    Anyway the distortion on VORPX DESKTOP VIEWER i think is for another reason (or Watcher…. is the problem….)

    naiveplayer88
    Participant

    There is no brainwarp page in Pitool, I downloaded yesterday
    Why, check version isn’t enough?

    Or maybe it is accessible only by who have complete the room setup with controllers and basestations

    Oh thank you I never understood where that Video panel was, I saw on the review video but i never found that, thank you !

    Anyway I noticed few minutes ago that if I put in Pause Watcher the two invisible lines disappear, but the strange distorion remain

    Resume Watcher obviously makes appear again…

    What does it means?

    naiveplayer88
    Participant

    Obviously i read it all before ask in the forum

    Maybe the only thing could be MSI afterburner, but it wasn’t running…

    I don’t see how to adjust it by myself
    —-
    Turn on smart smoothing: should be on to avoid judder I don’t understand if it means HIDDEN AREA MASK…
    I don’t have controllers and base station, and i don’t think i can chose the refresh rate…

    i don’t know where to chose this SteamVR: Video: Manual Override: 50%

Viewing 4 posts - 1 through 4 (of 4 total)

Spread the word. Share this post!