Engines Supported

Homepage Forums General vorpX Discussion Engines Supported

Viewing 9 posts - 1 through 9 (of 9 total)
  • Author
    Posts
  • #172938
    BlueKnight
    Participant

    Hello is there a list of all the supported engines somewhere and maybe a good working profile for the engine that is included to copy from. It is a royal pain to go to a profile to copy stuff not knowing how well it works.

    It would be great if we get a compatibility list started from here:
    https://en.wikipedia.org/wiki/List_of_game_engines

    #172939
    dellrifter22
    Participant

    RJK’s Engine Checker page is quite helpful for starters.

    I’ve seen another spreadsheet somewhere that shows a lot of games that have been tested for working 3D, but don’t have it on me right now.

    #172942
    BlueKnight
    Participant

    Thank you very much… have been looking for something like this

    #172944
    steph12
    Participant

    wow i never knew someone made a page listing games/engines supported, amazing stuff RJK !!! thanks a lot !

    #172945
    RJK_
    Participant

    Hello guys, has anyone of you made a Champions Online submission this morning ? If so, i would like to point out that vorpX does not support any 3D reconstruction by default, each game needs 3D enabled through a profile. I am pretty much shure that the 3D reconstruction page of vorpX did not say “Geoemetry”. I cant confirm that game, so please check again and report back. Tell us which profile you have used for the game to run in “Geometry Mode”.

    Anyway Thanks for the new engine. I have added some games to the Cryptic Engine List.

    #172946
    BlueKnight
    Participant

    I did. I am going through the games that I am playing is installed and seeing which ones work. This just worked on its own without needing a profile. Just attached and then went in and was able to enable 3D support.

    #172947
    RJK_
    Participant

    Thank you, can you confirm it said “Geometry” or did it say something like “Z-Buffer” ?

    #172948
    BlueKnight
    Participant

    Geometry … if I can figure out what profile it uses by default, I can make and upload a profile for it.

    #172949
    RJK_
    Participant

    Very strange. As far i know the engine supports OpenGL, may be it has something to do with that.

    May be Ralf can give a short comment on what possibly causes this. In my eyes VorpoX shouldnt provide G3D without a profile.

Viewing 9 posts - 1 through 9 (of 9 total)
  • You must be logged in to reply to this topic.

Spread the word. Share this post!